How to Use a Lattice Stitch Coverall for Easy Diaper Changes
By TANE organics | Published: 2026-11-03
Category: Guides pratiques
A lattice stitch coverall can make diaper changes simpler if you work with the front buttons, not against them. Here are the steps and the one mistake to avoid.
Quick answer
To make diaper changes easy with a lattice stitch coverall, open only the front buttons, slide the legs out, and change the diaper without pulling the coverall over the head. Always check that the inner leg opening is fully clear before refastening.
Why the front closure matters more than the knit
The Lattice Stitch Coverall uses natural shell buttons down the center front. That means you can open the garment flat rather than stretching it over your baby’s head. For a newborn, this is the difference between a calm change and a wrestling match.
The lattice stitch itself is breathable but substantial, so the coverall holds its shape when you open and close the front. You do not need to unbutton the entire garment—just enough to free the legs and diaper area. The 2x2 rib trim at the borders helps the openings stay put while you work.
When a button-front coverall is not the easiest choice
If your baby is a deep sleeper or very wiggly, a zipper footie may be faster for middle-of-the-night changes. Button-front coveralls like this one are best for daytime changes when you can lay your baby flat and take an extra few seconds. Also, the shell buttons are not meant to be yanked—if you rush, you can miss a buttonhole and stretch the placket.
Step-by-step diaper change with a lattice stitch coverall
- Lay the coverall flat and open the front: Unbutton the shell buttons from the bottom up to the chest, then fold the front panels outward. Common mistake: unbuttoning from the top down can cause the placket to twist and miss a buttonhole. Check that both front panels lie completely flat before you lift your baby.
- Slide the legs out without stretching the knit: Support your baby’s hips and gently guide each leg out of the leg opening. Do not pull on the rib trim. If the coverall has a crotch closure, unfasten it first so the legs move freely. If the leg opening feels tight, open one more button rather than tugging.
- Change the diaper with the coverall pushed up: Fold the front panels up and away from the diaper area. Keep the back of the coverall under your baby’s bottom to avoid a cold shock. Wipe and fasten the new diaper as usual. Make sure no fabric is trapped inside the diaper before you close it.
- Refasten the front starting from the bottom: Button the lowest button first, then work upward, matching each shell button to its hole. Common mistake: starting at the neck can leave the bottom misaligned and the leg openings uneven. Run a finger along the inner leg opening to confirm no skin or diaper is pinched.
- Check the fit at the legs and chest: The 2x2 rib trim should sit flat against the skin without digging in. You should be able to slide one finger under the leg opening. If the coverall pulls across the chest, size up rather than forcing the buttons. A coverall that leaves red marks is too small, even if the buttons close.
Product facts
- Lattice Stitch Coverall: Natural shell buttons dot the center front closure. A full front opening lets you change the diaper without pulling the coverall over the head.
Lattice Stitch Coverall - Lattice Stitch Coverall: The lattice stitch creates breathable yet substantial coverage. The knit holds its shape when you open and close the front, so the coverall stays easy to handle.
- Lattice Stitch Coverall: Certified organic cotton yarn with a border of 2x2 rib trim. The rib trim helps the leg and front openings keep their shape during repeated changes.
